World Water Day – 2017 163 Paper No. 138 PRESENCE OF HEAVY METALS IN SOLID WASTE LEACHATE AND ITS REMOVAL USING AGRICULTURAL WASTE Nadeem Hussain, Muhammad Anwar Baig, Azhar Iqbal & Shahid Rehman 164 World Water Day – 2017 World Water Day – 2017 165 PRESENCE OF HEAVY METALS IN SOLID WASTE LEACHATE AND ITS REMOVAL USING AGRICULTURAL WASTE By: Nadeem Hussain1, Muhammad Anwar Baig2, Azhar Iqbal3, Shahid Rehman4 Abstract Municipal solid waste leachate contains many contaminations like organic pollutants and toxic metals which cause serious effect on human healt h and environment. In this study, removal efficiency of toxic metals including Pb, Cr, Cu and Co by using agriculture waste adsorbents i.e. rice husk and corn cub was observed. Under Batch sorption experiment the parameters including contact time, dosage o f adsorbents and pH were studied. Concentration of metals was determined by using atomic adsorption spectroscopy and it was observed that various adsorbents exhibited differently at various pH levels, the adsorption efficiency is directly proportional to contact time and metals ion concentration is inversely proportional to the amount of adsorbents. Rice husk showed better adsorption (90 to 95 %) at pH range (2-5) and corn cub performed relatively better (90%) at neutral pH 7. It was found that Removal of heavy metals using locally available agriculture waste is cheaper and environmental friendly. Key words: Municipal solid waste leachate, Heavy Metals, Adsorption efficiency Introduction Landfill leachate is a complex wastewater generated when the moisture c ontent of a landfilled solid waste is higher than its field capacity [1]. The organic carbon compounds (e.g. BOD, COD), nitrogenous compounds, and metal ions are generally main pollutants in landfill leachate [2, 3]. The quality and quantity of leachate va ries from landfill to landfill, and over times, as a particular landfill ages, that is why the selection and design of leachate treatment system are not so simple. Landfill leachate often contain various toxic metals such as Barium, Copper, Nickel, Calcium, Cadmium, Chromium, Mercury, Zinc and Cobalt [3]. Varieties of industrial activities become cause of these heavy metals origination and waste sources and some are well known toxic and carcinogenic. The environment is threated by residual metals on the one hand and on the other hand theses metals cause serious detrimental effects on aquatic ecosystems [4]. Sometimes landfill leachate permeates through landfill liners and becomes cause of contamination of the ground water. So we can say that the 1 IESE, National University of Science and Technology, Islamabad Pakistan, tybarana@yahoo.com 2 IESE, National University of Science and Technology, Islamabad Pakistan, ma_baig@iese.nust.edu.pk 3 IESE, National University of Science and Technology, Islamabad Pakistan, azharchemist@hotmail.com 4 PCSIR Laboratories Complex, Lahore Pakistan, shahid_pcsir@hotmail.com 166 World Water Day – 2017 removal of h eavy metals from landfill leachate is important matter that requires proper consideration. Traditionally, conventional landfill leachate treatment processes have been similar to those that have been used for regular wastewater. The main approaches include: biological, physical and chemical treatment processes. Biological treatment processes primarily remove high concentrations of organic compounds. However, to date, there is no evidence indicating that biological leachate treatment processes can provide the adequate microbial transformations of heavy metals through the selection of suitable microorganism [5, 6]. Besides most chemical and physical treatment processes prove costly when removal of heavy metals considered [7,8]. It has been identified by several researchers that adsorption is the most appropriate process for heavy metals removal [9,10]. Activated carbon is used as the main adsorption medium in traditional adsorption processes, but it is not so cheap and particularly effective for heavy metals. Ma ny investigations have shown that natural low cost materials as adsorbents for heavy metals removal from aqueous solution and waste water, are alternative to activated carbon. These include: chitin and chitosan [11], macroalgae [12], etc. In this study ric e husk and corn cob were tested as potential natural adsorbents for the removal of heavy metals from leachate. In Pakistan, there are extensive unexplored agriculture wastes, which are following the hierarchy of waste management strategies. There wastes possess high efficiency of adsorption and can be utilized for the treatment of waste water. MATERIALS AND METHODS Material collection The municipal solid waste leachate and low cast agricultural adsorbents were collected from different places. Leachate was c ollected from Losar Dumpsite (an official dumpsite of Rawalpindi city), Pakistan. Per day municipal solid waste is dumped in Losar is about 1,200 metric tons. Most of the waste which is dumped is organic. Low cost agricultural adsorbents includes Rice Husk and Corn Cob were collected from local market where these are readily available. Leachate and Adsorbents Preparation Leachate was filtered using filter paper of 0.1µ to remove suspensions for further experiment. The adsorbents were also washed in plastic tubs to clean them from dust using distilled water. Adsorbents were then oven dried at 105ºC for 24 hours [13]. Adsorbents were ground to make in powder form using laboratory mill, then sieved to 0.2mm. The material is quite ready for experimental analysis. Experimental Setup The batch experiment was used for adsorbent analysis. In batch experiment 50ml leachate sample with different dosage 1, 2, 3, and 4g of adsorbent add in 250ml flask and flask was kept on shaking using Shaker (Thermolyne Sybron, Big Bi ll SE Rotator/Shaker) at 150 round per minute in different 1, 2, 3, and 4hrs time intervals at constant temperature 18º C ± 2. The pH of leachate was changed by using 0.1M H 2SO4 World Water Day – 2017 167 and 0.1N NaOH solutions. After shaking at different time intervals sample was then filtered using filter paper of 0.1µ and prepared for metals analysis using Atomic Absorption Spectroscopy (AAS). Leachate analysis The basic parameters of leachate, pH and Electrical Conductivity were analyzed using pH meter (WTW pH 526) and EC meter (inoLab pH/Cond 720). The analysis of chemical oxygen demand was conducted in PTFE vial which were heated in COD reactor (HACH) at 120oC for 2 hrs. X -Ray Fluorescence (XRF) Elemental Analyser JEOL JSX 3202 M Elemental Analysis (Na-U) was used to analyse me tals present in leachate. The Atomic Absorption Spectroscopy (AAS) (AAnalyst 800) was used for quantitative analysis of metals present in leachate. The amount of metal ion adsorbed was calculated by using equation 1; % adsorption = (Co – Ce)/Ce X 100 (1) Where; Co = Initial concentration of metal ions Ce = Final concentration of metal ions RESULT AND DISCUSSION Effect of Contact time The effect of contact time of adsorption efficiency has been showed in figure 1 for rice husk and in figure 2 for corn cob. Our results showed that the adsorption efficiency is directly proportional to contact time. The adsorption increased with increased the contact time till the equilibrium attained. This is concurrent with previous studies [14]. The percent adsorption of di fferent metals found different the Pb (89.5%), Cr (90.1%), Cu (86.1%), Co (78.9 %) for rice husk and Pb (80 %), Cr (77.6 %), Cu (75.6 %), Co (62.5 %) for corn cob were found. Maximum adsorption obtained at 4 hours contact time. There is no significant effect on adsorption by increasing further contact time, it may be due to the saturation of active sides of adsorbent and achievement of equilibrium at 4 hours. Figure 1: Effect of contact time using 4 g sorbent dose of rice husk 168 World Water Day – 2017 Figure 2: Effect of contact time using 4 g sorbent dose of corn cob Effect of Dosage The effect of dosage of adsorbents on the removal of heavy metals by rice husk is shown in figure 3 and by corn cob is shown in figure 4. The percent adsorption of different metals found different the Pb (89.5%), Cr (90.1%), Cu (86.1%), Co (78.9 %) for rice husk and Pb (80 %), Cr (77.6 %), Cu (75.6 %), Co (62.5 %) for corn cob were found. It is anticipated that metals ion concentration is inversely proportional to the amount of adsorbents, which me ans that heavy metals concentration in solution decreases with increasing the dose of adsorbents till the equilibrium is attained. This is concurrent of the previous studies [15]. Figure 3 : Effect of sorbent dose of rice husk World Water Day – 2017 169 Figure 4: Effect of sorbent dose of conr cob Effect of pH When optimum contact time and dosage of adsorbent was identified then further to verify the pH effect as one of important factors on the heavy metals (Pb, Cd, Cr, and Co) removal using rice husk and corn cob, different expe riments were performed by changing pH of leachate i.e. 2, 5, 9 and 11. It is also reported by several scientists that adsorption is pH dependent [16, 17]. Our results showed in figure 5 and figure 6, the maximum adsorption efficiency of rice husk obtained at pH 2 for Pb (95 %), Cr (93.7 %), Cu (93.3 %), Co (90.4 %) and for corn cob Pb (80 %), Cr (77.5 %), Cu (75.6 %), Co (62.5 %) at pH 7.5. Figure 5: The removal of heavy metals in % studied at various pH using rice husk 170 World Water Day – 2017 Figure 6: The removal of heavy metals in % studied at various pH using corn cob Conclusion The rice husk and corn cob are low cost easily available agricultural waste substances and are very effective adsorbents for heavy metals removal in leachates solution. The removal efficiency of ric e husk (95 %) is significantly better at pH 2 as compare to the removal efficiency of corn cob (90%) which showed better efficiency at neutral pH. The rice husk and corn cob are very useful adsorbents for the removal of heavy metals in municipal solid waste leachate. References Robinson, A.H.; 2004; Landfill leachate treatment: An article based on a paper with the same title, which was presented at the 5th international Conference on Membrane Bioreactors (MBR5); 9 pp. Aziz, H.A., Adlan, M.N., Zahari, M.S.M. and S.Alias; 2004; Removal of ammoniacal nitrogen from municipal solid waste leachate by using activated carbon and limestone; Water Management and Research; 22; p.371-375. Baun, D.L. and Christensen, T.H.; 2004; Speciation of heavy metals in landfill lea chate: a review; Waste Management & Research; 22; p. 3-23. Papageorgiou, S.K., Katsaros. F.K., Koulelos, E.P., Nolan, J.W., Deit, H.L., and Kanellopoulos, N.K.; 2006; Heavy metal sorption by calcium alginate beads from Laminaria digitata; Journal of Hazardous Materials; B 137; p. 1765-1772. Enzminger, J.D., Robertson, D., Ahlert, R.C., and Kosson, D.S.; 1987; Treatment of landfill leachates; Journal of Hazardous Materials; 14; p. 83-101. Norberg, A.B. and Persson, H.; 1984; Accumulation of heavy metal ions by zooglea ramigere; Biotechnol. Bioeng.; 26; p. 239-346. World Water Day – 2017 171 Metcalf and Eddy, INC; 2003; Wastewater Engineering: Treatment and Reuse, McGraw Hill series in civil and environmental engineering; 4thedn; McGraw -Hill; New York; 1819 pp. Wiszniowski, J., Robert, D., Surmacz -Gorska, J., Miksch, K., and Weber, J.V.; 2006; Landfill leachate treatment methods: a review; Environ Chem Lett; 4; p. 51-61. Rodriguez, J., Castrilon, L., Mararion, E., Sastre, H., and Fernandez, E.; 2004; Removal of non-biodegradable organic matter from landfill leachate by adsorption; Water Research; 38; p. 3297-3303. McLellan, J.K. and Rock, C.A.; 1988; Pretreating landfill leachate with peat to remove metals; Water, Air, and Soil Pollution; 37; p. 203-215. Rae, I.B. and Gibb, S.W.; 2003; Removal of metals from aqueous solutions using natural chitinous materials; Water Science and Technology; Vol.47; No.10; p. 189-196. Li, Ying Xia, Yun Wang, and Feng Juan Zhao.; (2015); “Kinetic and equilibrium studies of chromium (VI) biosorption by spent m acroalgae Polysiphonia urceolata and Chondrus ocellatus.” Biotechnology & Biotechnological Equipment 29, no. 3: 498-505.. Abdel Salam, E. O., Reiad, A. N. and ElShafei, M. M. (2011). A study of removal characteristics of Heavy Metals from waste water by l ow-cost adsorbents. Journal of Advanced Research 2; p. 297-303. Lokendra ST, Pradeep S. 2013. Adsorption of Heavy Metal (Cd2+, Cr6+and Pb2+) from Synthetic Waste Water by Rice husk Adsorbent International Journal of Chemical Studies 1:78-86. Bishnoi NR, Bajaj M, Sharma N, Gupta A. 2004. Adsorption of Cr (VI) on activated rice husk carbon and activated alumina. Bioresource Technology 91:305-307. Yadav, Deepak, Meghna Kapur, Pradeep Kumar, and Monoj Kumar Mondal (2015). “Adsorptive removal of phosphate from aqueous solution using rice husk and fruit juice residue.” Process Safety and Environmental Protection 94: 402-409. Yao, Zhikan, Ying Li, Yue Cui, Ke Zheng, Baoku Zhu, Hong Xu, and Liping Zhu (2015). “Tertiary amine block copolymer containing ultrafiltratio n membrane with pH – dependent macromolecule sieving and Cr (VI) removal properties.” Desalination 355: 91-98. 172 World Water Day – 2017

Filename: 10-Presence-of-Heavy-Metal-Nadeem-Hussain.pdf
File Type: pdf
File Size: 379 KB
Categories: World Water Day 2017
Author: Nadeem Hussain